How shock absorbers work

(Extracted by K. Lutz)

Shock absorbers don’t really absorb shock, they dampen it, hence they are often referred to as dampers. Why is this important for you to know? To improve ride quality. Basically put, a shock absorbers sole purpose is to dampen the compression and rebound of any suspension system by controlling the speed at which a suspension cycles. Without them, your car would continue to bounce up and down until the kinetic energy is finally dissipated from the suspension’s springs (e.g. leaf springs, coil springs, torsion bar, etc.) and sea sickness may follow.

Now let’s think about the law of conservation of energy. With this law in mind, shocks will perform two functions. The first function is to slow the suspension’s cycling of compressing or rebounding. Secondly, since energy can’t be destroyed, the shock transforms the kinetic energy into heat as it dampens the “bouncing” of the springs. That’s it. That’s what a shock does.

Or otherwise put – in a vehicle, it reduces the effect of travelling over rough ground, leading to improved ride quality, and increase in comfort due to substantially reduced amplitude of disturbances. Without shock absorbers, the vehicle would have a bouncing ride, as energy is stored in the spring and then released to the vehicle, possibly exceeding the allowed range of suspension movement. Control of excessive suspension movement without shock absorption requires stiffer (higher rate) springs, which would in turn give a harsh ride.

Shock absorbers allow the use of soft (lower rate) springs while controlling the rate of suspension movement in response to bumps. They also, along with “bounce” in your tyres, dampen the motion of the unsprung weight up and down on the springiness of the tyre. Since the tyre is not as soft as the springs, effective wheel bounce damping may require stiffer shocks than would be ideal for the vehicle motion alone.

Spring-based shock absorbers commonly use coil springs or leaf springs, though torsion bars can be used in torsional shocks as well. Ideal springs alone, however, are not shock absorbers as springs only store and do not dissipate or absorb energy. Vehicles typically employ both springs or torsion bars as well as hydraulic shock absorbers. In this combination, “shock absorber” is reserved specifically for the hydraulic piston that absorbs and dissipates vibration. Below are some images which illustrate these principles, and the technical features of dampers.

Salisbury Rear Axle

Click here to download (TYPE, 1.31MB)

Click here to download (TYPE, 22.93MB)

The first link does not apply to the earlier 2 Litre models, but is more relevant to 405/6 onwards through Chrysler V8′s etc. This and other information has kindly been donated by Per Blomquist and comes from a Motor Trader article from May 1958. It is reproduced here so that the technically minded can get a better understanding of how things work. The second link is an article by Phillip Herbert.